Tonor G11 mic wallmount

I am apart of a club that has this microphone attached currently to the ceiling with pushpins and rubber-bands so I needed something to hold it better. This is just a quick 20 min build. I tool the mic and measured and made something to hold it. When printed I did use supports just for the clean look. I also printed as a prototype without and no physical issues just cosmetic. I did make it a few mm bigger because mine was tight. Also included is the .obj. I made it in Tinker Cad. I also used blank squares to reduce the amount of material when printed. Worked well. Holds it tight and a better solution than when I started.