1 / 6
Tubeless bike tire booster for cola bottle [ OpenSCAD ]
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple 3D printed bottle cap for making tubeless booster out of ~2L soda bottle.
- Ocena
- 1 / 5
- Polubienia
- 25
- Pobrania
- 90
- Wydruki
- 0
- Wyświetlenia
- 906
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (3)Wydruki i komentarze (Wydruki: 0) (Komentarze: 9)Remiksy (0)Kolekcje (50)Powiązane
Simple 3D printed bottle cap for making tubeless booster out of ~2L soda bottle.
Requires as little additional parts as possible, and they are dirt cheap.
Supports: doesnt require any, print upright, vertically.
Additionals:
- O-ring made out of old butyle inner tube, see photo
- PVC hose with internal diameter of about 6 mm, I used one from aliexpress
- Suitable tube clamps
- Electrial or PTFE tape to improve tube sealing
- Bike pump with SCHRADER valve
- Optionally paperclip to clamp hose. Otherwise one can just hold it in hand in tightly bent position
The source in OpenSCAD is provided, so you can easily play with it to optimize for your setup
Note: As always with tubeless boosters, Remove the tire valve core before use, unlike the photo which is just a setup demonstration