SandPaper Holder swing out design
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I created this Sandpaper holder that swings out on a threaded rod and snap into position with magnets.
- Ocena
- 0 / 5
- Polubienia
- 16
- Pobrania
- 71
- Wydruki
- 0
- Wyświetlenia
- 587
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This design has a small and a large holder, all held in place on a threaded rod and magnets.
I set Orca to use:
- 4 wall loops
- 15% infill
- No supports
Magnet size:
- M6 2mm
Rod size: $7.50
- M8 x 500mm
Nut:
- M8 Stainless Steel Nylon Lock Nut
- M8 Knob Nut
Small takes about 2hrs to print
Large takes 3hrs to print
I also have different mounts, one with a lid and one open… up to you.
My 500mm rod allowed me to add 5 large bins and 7 small bins.
I used a threaded nut on the bottom and a thumb screw knob on the top.
I added mine to a simple board with some French cleats to hold it in place.
Make sure the magnets are oriented so they all work together…
Hope you like this.