SandPaper Holder swing out design
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I created this Sandpaper holder that swings out on a threaded rod and snap into position with magnets.
- Rating
- 0 / 5
- Likes
- 16
- Downloads
- 71
- Makes
- 0
- Views
- 588
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This design has a small and a large holder, all held in place on a threaded rod and magnets.
I set Orca to use:
- 4 wall loops
- 15% infill
- No supports
Magnet size:
- M6 2mm
Rod size: $7.50
- M8 x 500mm
Nut:
- M8 Stainless Steel Nylon Lock Nut
- M8 Knob Nut
Small takes about 2hrs to print
Large takes 3hrs to print
I also have different mounts, one with a lid and one open… up to you.
My 500mm rod allowed me to add 5 large bins and 7 small bins.
I used a threaded nut on the bottom and a thumb screw knob on the top.
I added mine to a simple board with some French cleats to hold it in place.
Make sure the magnets are oriented so they all work together…
Hope you like this.