PS4 Thumbstick Adaptors
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A series of pop-on PS4 adaptors to make using the thumbsticks more accessible for play.
- Ocena
- 0 / 5
- Polubienia
- 30
- Pobrania
- 98
- Wydruki
- 0
- Wyświetlenia
- 1207
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Video Games
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This series of models hope to offer a variety of “swap-to-suite” PS4 thumbstick adaptors for adaptive play.
*Will likely be adding more/refining models. Open to suggestions, as each persons style of play may vary.
- - -
Pinwheel- Basic Grip
Anchor- Full, 6 Point, 5 Point
- Full- extended version of Pinwheel
- 6 Point- allowance for better access to D-pad/△, O, X, ▢
- 5 Point- more allowance for potential collision between joysticks
Rise- 18mm pad risen up 15mm
- Slice- trimmed one side for using two Rise adaptors at once
Arch- A rising arch that can place access to the thumbstick over the D-pad or △, O, X, ▢ buttons. Can also act as a handle to the thumb if positioned under the arch. [Needs support*]
- Hook- slightly hooked end for better pull
- Bulb- Reaches center of D-pad or △, O, X, ▢ (experimental inverse control)
- Bulbv2- higher bulb version of ^
- - -
Tested, and best printed, upside down in TPU. No supports necessary [unless noted*]
Filament: Polymaker's PolyFlex™ TPU95
Settings: (used PrusaSlicer's “Fillamentum Flexfill 98A” filament profile)