PC / Mining Rig Power Reset Button & LED holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
PC / Mining Rig Power Reset Button & LED holder
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 46
- Wydruki
- 0
- Wyświetlenia
- 171
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
If you find my designs useful, please consider sending a tip
This is a simple holder for an ATX/ PC Power and Reset button and also Power and HDD activity LEDs.
Dimensions are 48.5mm x 13.5mm x 10mm
I recently built the awesome "poor man's computer test-bench" https://www.thingiverse.com/thing:3081540 by Romanizer and happened to be using it with an older motherboard which did not have onboard power/reset buttons. I had the appropriate cable but nowhere to affix them to the test-bench so I designed this.
Designed to fit standard 8.5mm square buttons and 5mm LED's, the type of cable I used is pictured.
Added 2 sets of mounting screw holes so it can be mounted with the buttons facing out or up or just use double sided tape.
The buttons are an exact fit in the holder to avoid movement but will require securing in place (small amount of hot glue on the back is perfect). The LED's are a snug fit once pushed through the holes and will hold in place themselves (hot glue can always be used if you think they might come out)
Print Settings
Printer Brand:
Creality
Printer:
Ender 3 Pro
No
Supports:
No
0.2 or higher
Infill:
40%
Notes:
Printed with a brim and at 40% infill to give it some strength
I printed face down so no supports were required but it should print OK in any orientation as long as your printers bridging is OK
Category: Electronics