Raised feet for Auping Original Boxspring
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement feet for the Auping Original boxspring to increase ground clearance with approximately 2.5 centimeters.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 18
- Wydruki
- 0
- Wyświetlenia
- 116
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bedroom
- Licencja
- Creative Commons — Attribution
This part replaces the original bottom feet with a taller version to increase ground clearance. I needed this so my robot vacuum could get under the bed without getting stuck.
I printed this on a Bambu Lab X1C using eSUN PLA+.
Recommended print settings:
- PLA
- 0.2mm layer height
- 100% infill
- Supports for bottom layer (see below).
The part has been designed such that the weight of the bed can rest on a floor glider of sufficient height (e.g. 5mm felt). When printing this, make sure to use support for the bottom layer. I had great experience with PVA filament as support material.
The original part has a lower top section. To prevent the feet from slipping off when moving the bed, I made this section a bit taller. However, this required a small indent so it will fit with the notch. Keep this in mind when mounting the feet.