Raised feet for Auping Original Boxspring
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Replacement feet for the Auping Original boxspring to increase ground clearance with approximately 2.5 centimeters.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 18
- Makes
- 0
- Views
- 116
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Bedroom
- License
- Creative Commons — Attribution
This part replaces the original bottom feet with a taller version to increase ground clearance. I needed this so my robot vacuum could get under the bed without getting stuck.
I printed this on a Bambu Lab X1C using eSUN PLA+.
Recommended print settings:
- PLA
- 0.2mm layer height
- 100% infill
- Supports for bottom layer (see below).
The part has been designed such that the weight of the bed can rest on a floor glider of sufficient height (e.g. 5mm felt). When printing this, make sure to use support for the bottom layer. I had great experience with PVA filament as support material.
The original part has a lower top section. To prevent the feet from slipping off when moving the bed, I made this section a bit taller. However, this required a small indent so it will fit with the notch. Keep this in mind when mounting the feet.