Festool Cleantec Vacuum (female) Adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Some time ago I printed the festool cleantec female part by PwnCnC and it kinda worked. But if not mountet properly it…
- Ocena
- 5 / 5
- Polubienia
- 112
- Pobrania
- 781
- Wydruki
- 1
- Wyświetlenia
- 4102
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Share Alike
Some time ago I printed the festool cleantec female part by PwnCnC (from thingiverse) and it kinda worked. But if not mountet properly it leaks a lot of air. And it wiggled loose many times in my case :( Also it is very easy to overturn the male part.
All in all it doesn´t feel good and doesn´t work as well as the original part.
Yesturday I got a new machine and needed a fitting adapter. Because i created the male part some time ago (https://www.prusaprinters.org/prints/98001-festool-vacuum-cleander-adapter-male-part-miele-dy) it was an obvious step to take my own measurements and create a tighter female part.
So here you have a very tight fitting adapter. Just as tight as the original ones!
To use it for your own projects you can use the .step file. Or just fit it to your adapter in Prusa Slic3r. (or others ofc.)
I also upload the adapter I use for my cyclone (it says 50 mm but its a little over 50 mm to fit tightly!)
Have fun and keep printin!