1 / 3
Mold to make a silicone o-ring for the Open Ball vise base.
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mold to make a silicone o-ring for the Open Ball vise base.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 42
- Wydruki
- 0
- Wyświetlenia
- 396
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
SzczegółyPliki (3)Wydruki i komentarze (Wydruki: 0) (Komentarze: 2)Remiksy (0)Kolekcje (10)Powiązane
I've had a problem finding a proper rubber band for the base of the famous Open Ball vise.
This is my temporary (or not-so-temporary) solution - to make my own.
The result and its sturdiness may vary depending on the silicone you use, but it is easy to make a new one.
BOM:
- Kinda any silicone which can hold its form to
- 6x M3 screws (any length from 12mm to 20mm will do)
- 6x M3 nuts
Instructions:
- Assemble the mold with the hardware.
- Apply a soapy water to it generously to serve as a release agent.
- Apply an excessive amount of silicone into the groove. (The leftovers will be squeezed out later).
- Press in either the mockup ball or the real ball of the vice. It should be covered in a soapy water or another release agent as well.