Razer Wolverine V2 Chroma M3/M4 Replacement Paddles Repair
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
M3 and/or M4 back button replacement printable part for the Razer Wolverine V2 Chroma.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 31
- Wydruki
- 0
- Wyświetlenia
- 384
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Video Games
- Licencja
- Standard Digital File License
M3 and/or M4 back button replacement printable part for the Razer Wolverine V2 Chroma.
Tried a few different designs. This one feels exactly the same as the original button. I have been using this printed part for around 4 months and it stills feels great, never broke.
To install the replacement buttons, you must disassemble the front and back pieces of your controller to access the back buttons. There are a few existing youtube videos on how to do so.
Repair instructions:
1- Using wire cutters and a utility knife, snip the remaining prongs holding the broken button and remove the plate holding the prongs by shaving off the 3 plastic weld spots on top (keep the 3 nibs attached).
2- Insert the two ends of the 3D printed part inside the button and apply super glue.
3- Unscrew the screw above the button.
4- Align the 3 nibs with the holes on the top mounting plate and place the replacement part. (Optional: apply glue under the top mounting plate)
5- Screw the screw back in over the replacement part.
6- Reassemble your controller.
PRINT SETTINGS:
Easier to print as shown in last picture. You can also print it at 90° for better strength or if you use PLA filament.
- PETG
- 0.4 mm nozzle
- 0.16 mm layer height
- 100% infill
- 2 wall loops
- 6+ mm brim
- Supports ON