Multiboard Universal Build Plate Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Build plate holder for Multiboard. Two-piece design holds up to five plates of any single width.
- Ocena
- 4,917 / 5
- Polubienia
- 126
- Pobrania
- 521
- Wydruki
- 12
- Wyświetlenia
- 1731
- Oceny
- 12
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Share Alike
I wanted a build plate holder that could handle multiple plates, and mount on multiboard without feeling like it would pull off if I pulled out a plate badly.
Features of this holder:
Five slots, 1.2mm deep. Will hold even my thickest build plate.
Two pieces, place them at whatever width you need. The slots are 40mm wide on each side, so plenty of support if your width is not “perfect” on a 25mm increment.
Two pieces are much easier to print, will fit easily on small printers like the Prusa Mini or Bambu Mini.
Each slot is staggered by 5mm vertically, making it easier to see and pull the plate you want.
Mounts using four Large multiboard bolts, two on each side of the holder. A 9mm bolt should be sufficient, but I use 13mm because I'm paranoid. The holder is rock-solid on the multiboard.
Note: You will need to print four Large Multiboard Bolts 9mm or 13mm, these are not included in the print files. They can be found at https://www.multiboard.io/parts-library/threads/
-- 18 Dec 2025 Added a side guid for very large plates
I recently got a Sovol SV08, which has 355mm plates. When just using the lower corner holders, the plates were "sagging" outward. I created a guid to put on one side near the upper edge of the plates that will keep the plates vertical, and prevent them from flexing. You should only need one of these on one side. putting one on each side would make adding and removing the plates annoying.