Reolink E1 mount - Magnet Wall and Table mount

Reolink E1 Mount - Wall and Table Tilt Mount

        I like the Reolink camera for monitoring my home, but when you place it on a table or even on a side wall, the angles are not always ideal. To address this, I designed these tilt mounts to provide a better viewing angle.

        The adapters I designed and printed require the original adapter that comes with the Reolink camera for mounting. I designed the adapter to be fixed with M5x10 screws, which are typically used for mounting computer coolers. These screws are great for securing into plastic, and I also happened to have them at home. However, you can use other types of screws if needed.

The side wall adapter was developed to be used with magnets, as I already had metal bars fixed to the wall. The magnets I used have the following dimensions: 60x10x5mm (10 pieces).

Simply print the wall tilt mount and attach the magnets.

        The table tilt adapter can be printed easily and then used to attach the original camera adapter. 

        In case you've lost the original adapter, I made a remix of a Reolink adapter that works very well, which can be found at this link. https://www.printables.com/model/1073620-reolink-e1-mount-new-and-old-model-adapted-for-my

        Please note that Reolink has changed the screw positions on some adapters. If this applies to your case, the original adapter may not work, and it's better to print the correct adapter as described in the link above.