Bed lock leveling wheel clickers - ender3 series - e3max - Gulfcoast Robotics e3 plate

I tried 120 clicks, but was too small and overkill, and the click tactile feedback wasn't strong enough to my taste. So picked 60 to match Klipper minute:second approach when using SCREWS_TILT_CALCULATE.

These, fresh at least, have a nice tactile feedback, was planing on using M4 locknut, but didn't have any on hand yet, and they work great with standard M4 nuts

the diagonal clicker are the same, but mirrored for the opposite diagonal. they are marked with X Y to easily match which corner goes where

I only tested it with PETG. not sure how long they would last if screwed/unscrewed many times, but for normal usage should last a while.

keep outer wall speed "slow" to have detailed notches (I print at 60mm/s 4K) the inside can be at whatever you wish (I did 120mm/s 8K)

I also redrew the e3max Neo bed underplatform as the ones I found online (for CR10) were not exact, I assume this should work on CR10 as well, but can't confirm.

This work on ender3/pro/v2 etc and gulfcoast robotic e3 plate

Wheels are 47mm in diameter (stock are 60mm), and 8.6mm tall

No print support needed

Also added wheels with tighter hex nut hole tolerance, first one I made had it at 7.0mm (measured at two opposite walls), which ended up a tiny bit loose with the ones I have on hand, new one has a 6.8mm hex nut opening. leaving both model here in case M4 lock nut are larger.

------

Support me on Patreon !

https://patreon.com/squirrelf3d

or buy me a coffee
https://ko-fi.com/squirrelf3d
https://www.buymeacoffee.com/squirrelf