Pull up bar bumpers
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Pull up bar bumpers
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 77
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Indoor Sports
- Licencja
- Creative Commons — Attribution — Share Alike
Sometimes I close the door where my pull up bar is hanging. This, of course, results in the bar falling down marring up my floor. I set out to correct this and prevent further damage. I contemplated securing the bar to the ceiling with a piece of cordage.. But then I thought about “Home alone” and the loss of teeth the next time I forget.
So the model contains TPU bumpers for the domed M6 nuts as well as replacement end caps for the bar itself. 0.2 layer height and 20% infill. No supports.
Secured the pieces with a small amount of cyano acrylate, easy enough to remove if the need arises.
The inner diameter of the bar is 22 mm. Source file included for adapting to various models.