Open ended wrench holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Wrench holder to be mounted on a pegboard. Designed to hold the wrenches from 6 to 19 mm.You must print 2 base_sliding…
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 89
- Wydruki
- 0
- Wyświetlenia
- 449
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
Wrench holder to be mounted on a pegboard. Designed to hold the wrenches from 6 to 19 mm.
You must print 2 base_sliding (hook) + 1 support_cles (holder).
The holes for the hook in the holder have a spacing of 45mm horizontally, and 50mm vertically. The vertical disposition of the holes add some flexibility to place it on your wall
The type of pegboard it was designed for: https://www.leroymerlin.fr/produits/quincaillerie/rangement-utilitaire/console-et-cremaillere/systeme-cremaillere-simple-pour-console/lot-de-2-panneaux-perfores-acier-spaceo-blanc-80x20cm-82658409.html
However, as long you pegboard has similar holes shape and :
- An horizontal hole spacing of 45mm
- Hole width approx. 5mm (the hooks are designed with a thickness of 4.6mm)
It should fit yours
Print Settings
Printer:
DBot
Rafts:
No
No
Resolution:
200
38
Filament: PolyMaker PETG GreyHow I Designed This
This was designed in TopSolid
First I have imported in TopSolid, the wrenches from traceparts
I have positionned them in an assembly and then designed the holder directly in the assembly.
At first I have just created a block that would fit my wrenches:
Then I removed the inner part and substracted the wrenches shapes from my holder:
Then I computed in TopSolid the location of the center of mass of the assembly (wrenches + holder) to place at least 1 hole for the hooks near it (just above it in fact)
I then added the numbers, some fillet and chamfers to have a nicer shape and smoother angle for an easier printing
Category: Tool Holders & Boxes