1 / 5
Carpuride 702 Pro Mount for 16.2mm (BMW R1200GS) Bar — zdjęcie 1
1 / 5

Carpuride 702 Pro Mount for 16.2mm (BMW R1200GS) Bar

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Mount for a Carpuride 702(B) Pro Carplay Display for a BMW with 16.x mm bar if the BMW accessory mount is not useable.

Ocena
0 / 5
Polubienia
7
Pobrania
90
Wydruki
0
Wyświetlenia
1475
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Automotive
Licencja
GNU General Public License v2.0

I bought a BMW R1200GS and a Carpuride 702B Pro Carplay Display. The R1200GS was missing the BMW accessory mount so I could not use that. It also turns out that the Carpuride 702(B) Pro uses the mount for the BMW bracket or alternatively the 1" RAM mount ball as some kind of heat spreader. There is a thermal pad that connects the metal mount to a DSP on the board. With that in mind, this mount here retains the metal heat spreader and screws on top. You need longer screws (M3) to connect the new mount to the existing one. It is designed to sit as low as possible - providing access to the speedo and warning lights while partially covering the tachometer. I am quite small - I can still see the lower rev range (up to 2.5k RPM) and the beginning of the red RPM range. If you are taller than 1.72m  your results may vary. I think it could also be mounted upside down so the display would sit way higher.

Notes:

  • Printed in Prusament PETG, 3 Walls, 80% infill. Overkill. Less infill would also work. 
  • 4x M3 to mount the bracket to the Carpuride Display
  • 4x M6 to connect the two brackets
  • Though the threads are modeled into the file, cleaning them after the print with a thread cutter helps to put less stress on the plastic
  • No supports needed while printing 

STEP files included. Feel free to modify as needed. Modeled in onshape - you can also find the drawings there.

Have fun printing & safe and enjoyable rides!

Update: Turns out, I looked up the wrong thread pitch for M6. Now M6 (x1) instead 6x0.75 (which would be fine pitch for 6mm bolts).

Tagi