1 / 4
Qidi Plus 4 SSR and Fan Mount for Tall Heatsink V1.0 — zdjęcie 1
1 / 4

Qidi Plus 4 SSR and Fan Mount for Tall Heatsink V1.0

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a mount for an aftermarket SSR with tall heatsink module for the Qidi Plus4.

Ocena
5 / 5
Polubienia
38
Pobrania
375
Wydruki
3
Wyświetlenia
1485
Oceny
2

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

This is a mounting solution for an aftermarket SSR module with tall heatsink for the Qidi Plus4. This mounts in place of the factory SSR PCB using the three mounting holes. You also have the option of mounting a 40x40x10 cooling fan onto the heatsink for additional cooling. The fan mount is toolless and snaps onto the heatsink. The main mounting plate can be attached/removed either with the fan mount attached or removed as well. 

The fan mount to heatsink will have a small amount of play due to the tolerances needed for small variations in heatsinks. 

Mounting hardware needed: 

The mounting plate should be able to be mounted using the factory screws and washers. I have provided a printable M3 washer if you choose to use it. You can adjust the height of these washers in your slicer as needed. 

The fan should be mounted to the fan mount using two or more M3 x 13 cap screws. Longer ones can be used if needed.

The heatsink should mount to the mounting plate using two M3 x 13 screws with appropriate washers. I have also provided a file you can print for tie-downs if you choose to use them.

Printing material recommendations:

You can pretty much use the standard materials, but I recommend PETG for the fan mount for the elasticity beneficial to the mounting fingers for repeated mounting and removal. I am also using ABS for the mounting plate and heatsink tie-downs for the rigidity and thermal properties.   

Change note: I have now confirmed that this does indeed fit my printer very well. Previously I hadn't had a chance to personally verify fitment.

This is my first upload and would appreciate any constructive feedback.  

 

ETA: I just added a mounting plate with smaller holes that should not require any washers to mount in place of the original Qidi Plus 4 SSR PCB

3DPrintSOS did an install using this mount. You can view it at the link below. I appreciate him trying it out. 

https://www.youtube.com/watch?v=kYKGGycYN2w

 

https://github.com/qidi-community/Plus4-Wiki/tree/main/content/heater-ssr-upgrade

Tagi