1 / 3
Bambulab P1S Enclosure Exhaust Outlet Connector For 4 Inch/100mm Ducting — zdjęcie 1
1 / 3

Bambulab P1S Enclosure Exhaust Outlet Connector For 4 Inch/100mm Ducting

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Bambulab P1S Enclosure Outlet Connector For 4 Inch/100mm Ducting. Connects magnetically and aligns with two M2 screws.

Ocena
0 / 5
Polubienia
26
Pobrania
328
Wydruki
0
Wyświetlenia
2154
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution — Noncommercial

Connector for adding ducted ventilation to your Bambulab P1S enclosure.

Once printed, glue neodymium magnets into the 4 slots on the back.

Screw in two M2 screws into the alignment holes. These don't screw into the enclosure, but just slot into the existing 2 holes in the enclosure back panel. Good for aligning nicely.

The screws should be 6-8mm long.

The connector attaches to 4 inch ventilation ducting. It's designed with a small ridge so the ducting doesn't slip off. Secure the ducting with cable ties.  You can ‘chain’ cable ties together to get a long enough tie to fit all the way around the 4 inch ducting.

Print Settings:

  • No supports required.
  • I used PETG for strength and longevity. 
  • Print with at least 5 walls for strength.

 

Tagi