Bambulab P1S Enclosure Exhaust Outlet Connector For 4 Inch/100mm Ducting
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Bambulab P1S Enclosure Outlet Connector For 4 Inch/100mm Ducting. Connects magnetically and aligns with two M2 screws.
- Rating
- 0 / 5
- Likes
- 26
- Downloads
- 328
- Makes
- 0
- Views
- 2,157
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial
Connector for adding ducted ventilation to your Bambulab P1S enclosure.
Once printed, glue neodymium magnets into the 4 slots on the back.
Screw in two M2 screws into the alignment holes. These don't screw into the enclosure, but just slot into the existing 2 holes in the enclosure back panel. Good for aligning nicely.
The screws should be 6-8mm long.
The connector attaches to 4 inch ventilation ducting. It's designed with a small ridge so the ducting doesn't slip off. Secure the ducting with cable ties. You can ‘chain’ cable ties together to get a long enough tie to fit all the way around the 4 inch ducting.
Print Settings:
- No supports required.
- I used PETG for strength and longevity.
- Print with at least 5 walls for strength.