1 / 11
Replica Guts Sword - Dragon Slayer from Berserk — zdjęcie 1
1 / 11

Replica Guts Sword - Dragon Slayer from Berserk

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Informacje o modelu

Źródło
Printables
Kategoria
Props
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Guts Sword - Dragon Slayer from Berserk.

I wanted to try and design a full sized sword. Guts sword seemed easy enough to make and paint.

At 100% scaling the sword is ~1.5m long and 22cm wide, and weighs about ~3kg.

Wall mount available here.

Parts you'll need:

Tools

Instructions

  • Print parts.
  • Slide all the parts onto the tube.
  • Using the tape measure, measure the excess tube length (it should be around 50cm).
  • Cut the tube down to ~1.30m long using the pipe cutter/hacksaw/grinder. Sand the end to remove any sharp bits of metal.
  • Using the pole as a guide glue Hilt A, Hilt B, and the blade cover together. Dont let the glue stick to the pole!
  • Using the pole as a guide glue Blade A, Blade B, Blade C, Blade D, and Blade E together. Dont let the glue stick to the pole!
  • Remove the pole. Let the glue cure for 24 hours. Cut off any excess.
  • Use the soldering iron to seal up any seams between the parts (I used 300c for PETG).
  • (Optional) Fill the blade gaps with expanding foam for added strength. You could also fill the tube with weights to try and balance the sword (its quite unwieldy).
  • (Optional) Let the foam cure for 24 hours. Cut off any excess.
  • Slide the hilt and blade parts onto the pole. Glue the Blade parts to the Hilt. Allow 24 hours to cure.
  • Cut off any excess glue. Use a soldering iron to seal up any seams between the 2 parts. Done!

For painting, I sanded the whole sword down with a 60 grit, then 120 grit then 180 grit sheet. I then filled any gaps with milliput then primed with some grey primer. Once the primer was dry I painted the sword with 3 coats of silver spray paint and then 2 coats of black spray paint just down the center of the blade. After the paint was dry, I covered the whole sword in clear lacquer to protect the paint. I then attached the leather to the handle using the glue; the reel in the link is just long enough to wind around the whole handle.


08/06/2024 V1.1: Removed infills.

21/07/2024 V2: Decreased hole size from 28.5mm to 26mm. Added Blade cover.

Print Settings

Printer Brand:

Creality

Printer:

Ender-3 S1

Rafts:

No

Supports:

No

Resolution:

0.2

Infill:

20%

Filament: Filamentive PETG Grey Notes:

Using 3 perimeters and cubic infill, printing all parts uses about 600m of filament.

Category: Props

Tagi