1 / 11
Replica Guts Sword - Dragon Slayer from Berserk — image 1
1 / 11

Replica Guts Sword - Dragon Slayer from Berserk

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Model information

Category
Props
License
Creative Commons — Attribution — Noncommercial — Share Alike

Guts Sword - Dragon Slayer from Berserk.

I wanted to try and design a full sized sword. Guts sword seemed easy enough to make and paint.

At 100% scaling the sword is ~1.5m long and 22cm wide, and weighs about ~3kg.

Wall mount available here.

Parts you'll need:

Tools

Instructions

  • Print parts.
  • Slide all the parts onto the tube.
  • Using the tape measure, measure the excess tube length (it should be around 50cm).
  • Cut the tube down to ~1.30m long using the pipe cutter/hacksaw/grinder. Sand the end to remove any sharp bits of metal.
  • Using the pole as a guide glue Hilt A, Hilt B, and the blade cover together. Dont let the glue stick to the pole!
  • Using the pole as a guide glue Blade A, Blade B, Blade C, Blade D, and Blade E together. Dont let the glue stick to the pole!
  • Remove the pole. Let the glue cure for 24 hours. Cut off any excess.
  • Use the soldering iron to seal up any seams between the parts (I used 300c for PETG).
  • (Optional) Fill the blade gaps with expanding foam for added strength. You could also fill the tube with weights to try and balance the sword (its quite unwieldy).
  • (Optional) Let the foam cure for 24 hours. Cut off any excess.
  • Slide the hilt and blade parts onto the pole. Glue the Blade parts to the Hilt. Allow 24 hours to cure.
  • Cut off any excess glue. Use a soldering iron to seal up any seams between the 2 parts. Done!

For painting, I sanded the whole sword down with a 60 grit, then 120 grit then 180 grit sheet. I then filled any gaps with milliput then primed with some grey primer. Once the primer was dry I painted the sword with 3 coats of silver spray paint and then 2 coats of black spray paint just down the center of the blade. After the paint was dry, I covered the whole sword in clear lacquer to protect the paint. I then attached the leather to the handle using the glue; the reel in the link is just long enough to wind around the whole handle.


08/06/2024 V1.1: Removed infills.

21/07/2024 V2: Decreased hole size from 28.5mm to 26mm. Added Blade cover.

Print Settings

Printer Brand:

Creality

Printer:

Ender-3 S1

Rafts:

No

Supports:

No

Resolution:

0.2

Infill:

20%

Filament: Filamentive PETG Grey Notes:

Using 3 perimeters and cubic infill, printing all parts uses about 600m of filament.

Category: Props

Tags