MK4S xLCD Vers. A backcover for prusa enclosure with integrated LED diffusor
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Allows to mount the injection-molded MK4S xLCD housing to the original prusa enclosure without blocking the doors.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 30
- Wydruki
- 1
- Wyświetlenia
- 216
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- GNU General Public License v3.0
When trying to mount the original injection-molded housing of the MK4S xLCD to the original prusa enclosure there are several issues:
- the holes for the screws do not align
- the position is to high, the xLCD would block the doors.
- the adapters designed by @prusa-research that are included in the ‘enclosure printable parts’ for the MK4 xLCD-housing do not fit the injection-molded cover.
- in case the enclosure is placed at the edge of a table the visibility of the status LEDs is bad as they need a reflective surface in close distance.
While there are various adapters here on printables, from my point of view an adapter for a broken design is not a satisfying solution. I therefore created a new backcover from scratch that nicely fits the front of the injection-molded cover. The distance of the mounts matches the existing holes at the front of the original prusa enclosure.
There are two versions:
- simple backcover, status LEDs illuminate the floor.
- backcover with integrated diffusor to be printed in 2 colors (using e.g. an MMU and transparent filament for the diffusor). Status LEDs are clearly visible.
the backcover fits the xLCD version A. (On the xLCD board version B THE PE connector is in a different position. If your xLCD board is Version B feel free to remix accordingly).
Print upside down, Perimeter 3, 20% infill, support on build-plate only with overhang-threshold 20°, brim enabled (for the main body it may work without brim, but I had trouble with the holders deseparating from the print-sheet when using petg on the textured sheet)
for the diffusor set Perimeter to 6, 100% infill, brim enabled
Updates:
23.11.2024 optimize overhangs for ‘support on buildplate only’