1 / 3
xTool AP2 dual inlet kit for M1 Ultra and F1 — zdjęcie 1
1 / 3

xTool AP2 dual inlet kit for M1 Ultra and F1

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Enables 2 xTool laser machines (M1U and F1) to be connected to the AP2 air purifier simultaneously.

Ocena
0 / 5
Polubienia
18
Pobrania
59
Wydruki
0
Wyświetlenia
888
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution — Noncommercial

About the kit

This kit allows you to connect the xTool M1 Ultra and F1 laser cutters/engravers simultaneously to the new AP2 air purifier.

There are 2 blast gate assemblies for shutting off the non-active machine to avoid suction loss.

The M1 blast gate has an angled duct to set it apart from the back of the machine.

Contents

The kit comprises:

  • 80mm elbow duct for the AP2 inlet port 
  • Dual manifold 84mm to twin 63mm  (connects to elbow duct)
  • M1 Ultra blast gate assembly - elbow outlet, spacer and gate, screw in pipe outlet
  • F1 blast gate assembly - 66mm outlet, spacer and gate, 63mm outlet

Additional parts required: 

  • 4x6mm M3 bolts and nuts for each blast gate assembly
  • Standard xTool 63mm pipe ends

Printing

I've printed mine in PLA on the Bambu P1P(S).

  • Layer height: 0.2mm
  • Wall loops: 6
  • 25% infill

The elbow duct, manifold and the elbow section of the M1U blast gate assembly benefit from tree supports.

I'm happy to answer questions about the setup.

Tagi