3DSets Wheel Spacer & Rotor
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a spacer used on models from 3DSets.com (both Landy and Rancher) to move the wheels and tires outward. Making…
- Ocena
- 5 / 5
- Polubienia
- 49
- Pobrania
- 167
- Wydruki
- 1
- Wyświetlenia
- 1289
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution
This is a spacer used on models from 3DSets.com (both Landy and Rancher) to move the wheels and tires outward. Making a wider stance and moving the wheels away from the shocks. Giving you more shock options, more potential for articulation, and greater stability.
You will need a 20mm or 25mm M3 screw to mount each spacer. You may need to shave a bit of plastic on the inside of the front fender well if you run a large off-road tire such as what is pictured. I did this with a dremel tool with a cutting wheel. (Shaving is only necessary if your tire rubs the front inner fender well when turning and will not be visible from the outside. On real, full scale off-road vehicles, this is often done by cutting or hammering at the seam of the body that is in the same location.)
I highly suggest printing these at 100% infill, .16-.18 line height, 205-210 degrees, at around 40mm/s, and 50% "lines" supports from the build plate.
Enjoy and post your makes!
If you found my Things useful, treat me to a cup of coffee by using the PayPal button below :) Buy me a cup of coffeeBuy me a cup of coffee $3.00 USDBuy me a massive cup of coffee $5.00 USDGive me a caffeine coma $10.00 USD
Category: Hobby