Pegboard or wall mount holder for Runwell hex keys
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Holder for the wonderful Runwell hex keys (from runwell.jp) to keep them easily accessible.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 26
- Wydruki
- 0
- Wyświetlenia
- 172
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
As seen on Tim DeBoer's gorgeous tool wall of fame.
Tool holder for the hex keys from Runwell Japan.
Runwell makes beautiful tools, and these hex keys are no different, but they're also high precision and really, really nice to work with. I don't even like L keys, and these are essentially really fancy L keys, but I find myself reaching for these all the time. Once I realized I was going for them so often, I decided that I had to make a holder so they could be right where I needed them.
Holds three keys, at the time of posting, they only offer the 4, 5 and 6mm keys. The order is not important as the profiles of the holder spots are the same. Open front entry makes it quicker to grab the keys than a full hole.
Provided in pegboard version and wall mount version that uses one or two screws. The pegboard version is designed around standard 1/8" thick MDF pegboard with a ¼"x1" pattern. This should also work with other pegboards, but I don't have those so have not tested it. The wall mount is designed for flat head screws with a maximum diameter of 4.5mm and a maximum head diameter of 9mm.
Print instructions
Nothing special here, if you print the pegboard version, you can enable supports for the upper pegs, but it can also be done without. The underside of the top pegs might not be clean, but since it'll be hidden in the pegboard, you won't see it.