1 / 3
Voron 2.4/Trident Top Hat Roof Rack Extrusion Spacer/Wire Channel — zdjęcie 1
1 / 3

Voron 2.4/Trident Top Hat Roof Rack Extrusion Spacer/Wire Channel

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

70mm spacer/wire channel to keep Roof Rack extrusions equally spaced, secure, and allow passing of wires between spacers

Ocena
5 / 5
Polubienia
16
Pobrania
42
Wydruki
2
Wyświetlenia
661
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

This is a spacer/wire channel to be connected between 2020 aluminum extrusions on the Top Hat Roof Rack. It is 70mm long with the end mounting caps which keeps the 89mm spacing for the filament rollers and filament dryer stand. I also am adding LED's to the bottoms of the extrusions facing down into the enclosure but hate seeing wires so there are holes in the bottom that allow wires to be run through them and remain invisible. Mounted using M3 screws and t-nuts to attach the end caps. I did place an M3x5x3 headset insert into the caps and used them to secure the center channel with small M3 screws, pretty janky but worked very well to my surprise. 

Tagi