SCX10 III Basecamp Front Bumper -- Pinched
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a front bumper that allows for good approach angle and has a much narrower profile then the original.
- Ocena
- 5 / 5
- Polubienia
- 17
- Pobrania
- 149
- Wydruki
- 1
- Wyświetlenia
- 748
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a front bumper that allows for good approach angle and has a much narrower profile then the original. My front bumper kept getting caught on the tires, so I designed this.
I used PETG-CF as the main material and used PLA for supports. I printed on an angle and had a 8mm brim with almost none of the bumper actually sitting on the build plate. All overhangs were reinforced up to 40 degrees with organic supports.
For print settings I used 4 parameters and 25% gyroid infill at .2mm layer height. For Prusa XL users see the following link for PETG with PLA supports.
I put the