1 / 5
K1/K1 Max/K1C MK6/MK7 Skeletor Knomi v2 Mount — zdjęcie 1
1 / 5

K1/K1 Max/K1C MK6/MK7 Skeletor Knomi v2 Mount

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a Knomi V2 mount for the Skeletor MK6 and upcoming MK7 toolhead covers.

Ocena
5 / 5
Polubienia
26
Pobrania
102
Wydruki
2
Wyświetlenia
2125
Oceny
2

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

This is a Knomi V2 mount for the Skeletor MK6 and upcoming MK7 toolhead mounts.  This will require slightly longer M3 screws to mount through the bezel and cap, through the stock fan and into the MK6 or MK7 mounting points.  

Link to Skeletor MK 6:

https://www.printables.com/model/961152-skeletor-mk6-a-creality-k1k1-maxk1c-toolhead-cover

I printed at 100% infill using Creality ASA.  Its just what I do.  Supports needed for the rear cap to print the arms.  

Knomi should press carefully into the bezel without any trouble.  Rear cap should slide loosely over the back.  The mounting screws will hold them both together snugly.  

I only use my Knomi for looks - I don't usually ever touch the screen, so I'm not 100% clear how sturdy it is to use this way.  My cablechain likes to push up against it when the print head is at the rear of the plate, but I don't notice any breaks in the mounting arms or any binding.

Don't mind the excess wiring…I had an extra long pair of wires to deal with the Devil Burner cover.  

I took the adhesive board off the wifi antenna and was able to curl it around the outside of the Knomi in the bezel.  It tucked away between the PCB and bezel.  I put a small piece of electrical tape over the end to protect the piece of solder there.  The back of the cap is cut out in a hex pattern - feel free to run the wifi wire through here and mount wherever.

11/26/2024 - Added a cutout to access the boot button

Special thanks to @tbkmaker for his help/support on this model.  

Tagi