Magnetic Stand for Raspberry Pi 3 and 4 Cases
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a Hex version of the magnetic clip or stand for the cases.
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 57
- Wydruki
- 0
- Wyświetlenia
- 944
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Wall-mounted
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
This is a Hex version of the magnetic clip or stand for the cases.
Printing this piece is successful when using an ooze shield.
There is a small sprocket that holds 4 [1/2" x 1/16"] D81 Magnets (K&J Magnets). The sprocket or magnet frame slides into the gap between the formed hexagonal cells and drops into pockets that align the magnets into the frame and you should touch a few drops of superglue, or abs glue, to hold it in place. I used a flat razer blade and a shim to hold the sprocket in the pocket that registers the magnets.
Print instructions
I printed this many times trying to find the best settings to avoid stringing and blobs on every island, finally found an ooze shield that worked well and printed clean parts.
The Hex and Snaptop cases fit into this Clip.
Printed in ABS