Magnetic Stand for Raspberry Pi 3 and 4 Cases
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€0.14 – €0.17 net (excluding VAT)
For file: sprocket4clip7.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.15 excluding VAT (range midpoint).
- Weight reported by the author
- 1 g
- Print time reported by the author
- 10.8 min
- Source material
- ABS
- Estimate material
- ABS
- Estimate printer
- Bambu Lab X1 Carbon - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
This is a Hex version of the magnetic clip or stand for the cases.
- Rating
- 0 / 5
- Likes
- 8
- Downloads
- 57
- Makes
- 0
- Views
- 946
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Wall-mounted
- License
- Creative Commons — Attribution — Noncommercial — NoDerivatives
This is a Hex version of the magnetic clip or stand for the cases.
Printing this piece is successful when using an ooze shield.
There is a small sprocket that holds 4 [1/2" x 1/16"] D81 Magnets (K&J Magnets). The sprocket or magnet frame slides into the gap between the formed hexagonal cells and drops into pockets that align the magnets into the frame and you should touch a few drops of superglue, or abs glue, to hold it in place. I used a flat razer blade and a shim to hold the sprocket in the pocket that registers the magnets.
Print instructions
I printed this many times trying to find the best settings to avoid stringing and blobs on every island, finally found an ooze shield that worked well and printed clean parts.
The Hex and Snaptop cases fit into this Clip.
Printed in ABS