2020 Door Latch
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Insulation Compatible 2020 Door Latch
- Ocena
- 0 / 5
- Polubienia
- 13
- Pobrania
- 56
- Wydruki
- 0
- Wyświetlenia
- 714
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
2020 Door Latch
This should be compatible with typical Clicky-Clack Fridge Door setups using 3mm weather stripping while also being compatible with thick insulation panels.
It will not last as forever but it's small and easy to repair if it looses its teeth.
It will leave plastic on the front of your frame that easily wipes off.
It will probably take two hands to open and close. I partially open the top latch then bottom latch with door held shut. I close with one hand holding door shut and in position with another locking the latches using the bridge and equal pressure.
It could be better, but it doesn't need to be better.
Bill of Materials
- 2x M3x25
- 2x M3 Roll in nuts
- 2x M3-5x1mm washer - or a stack to get near 1mm
- 4x M3x10-14mm - holes are tapped beyond the heatset
- 4x M3x4x5 heatsets
Print Specs
Parts are oriented as they should be printed.
- 0.4 nozzle
- 0.25 layers
- 4 walls
- 5 tops/bottoms
- 40% infill