1 / 5
Sock clip hanger / věšák na sušení ponožek
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
12.4 and 14.5mm rod diameter. Saves space and socks dry better. Works for panties too! STEP model included.
- Ocena
- 5 / 5
- Polubienia
- 62
- Pobrania
- 210
- Wydruki
- 10
- Wyświetlenia
- 1557
- Oceny
- 11
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bathroom
- Licencja
- Creative Commons — Attribution — Share Alike
SzczegółyPliki (11)Wydruki i komentarze (Wydruki: 10) (Komentarze: 11)Remiksy (1)Kolekcje (92)Powiązane
Inspired by this design:
Adjusted:
- Diameter to for ~12mm rod (metal drying rack side bar) and ~14.3mm rod (main frame)
- Shape of hooks - prints as 2 lines (use 0,5mm extrusion width) (no gap fills)
- Sufficient attachment (previous version broke, so I made it larger again)
- Hooks shaped with closing gap.
1st gap wider, 2nd gap narrower (works better for panties) - Made to fit Prusa MINI print bed (bit less than 180mm) (Set skirt loops to 0)
- Attachment to main frame (14.5mm) split to allow hanging wires go between. You can place in short side of hanger.
Print in PLA if you want to use it indoors and not on direct sun. PETG is recommended for outdoor use.