1 / 4
RCFactory Jabberwocky Cub Style Landing Gear — zdjęcie 1
1 / 4

RCFactory Jabberwocky Cub Style Landing Gear

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a very durable, sort of cub style landing gear for the RCFactory or TwistedHobbies Jabberwocky.

Ocena
0 / 5
Polubienia
10
Pobrania
52
Wydruki
0
Wyświetlenia
548
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
RC & Robotics
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

You will need:
 

  • 4mm SQUARE carbon rod (four 125mm ish sections in total so a 500mm rod should be enough or buy a 1000mm one if you wanna make 2)
  • 2 springs out of normal spring steel (ours have the dimensions of 4mm diameter 73mm length or 79.5 with the eyelets and a wire thickness of 0.7mm)
  • four 3.5mm x 20mm wood screws and washers to go along (at least thats what we used)
  • some M3 allthread (55mm per side should be enough)
  • M3 nuts and washers
  • Loctite (!!!)
  • Some paracord or whatever you wanna string up the springs with
  • 1x Main Plate
  • 2x Suspension Wheel printed with 100% infill (!!)
  • 2x Suspension Fuse

I printed this landing gear with Extrudr Flex Hard which gives it incredible durability. I also recommend printing the main plate with a few extra top and bottom layers and thicker walls as well as honeycomb infill. 

It has saved this Jabberwocky from a failsafe landing (due to powerloss) that had a somewhat steep decline from like 6m high. 

You will also have to remove the small overhangs on the bottom of the fuselage where the old landing gear goes so the entire width of the main plate can fit. A somewhat sharp hacksaw should do the trick just fine.

Tagi