Festool ETS EC150 Sander Clamp Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Sander holder that slides onto clamp bar, allowing for use around the shop.
- Ocena
- 0 / 5
- Polubienia
- 16
- Pobrania
- 41
- Wydruki
- 0
- Wyświetlenia
- 685
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
For the Festool ETS EC150 Sander with or without a pad saver installed. If a thick, soft backing pad (FUSION-TEC ST-STF D150/MJ2-M8-SW/Item #202459) is installed, the sander will NOT fit.
This holder slides onto the bar of an Irwin Quick Grip Mini Clamp (1/2 inch - 12.7mm bar width). Clamp to a suitable horizontal work surface to keep the sander handy, and out of the way when not needed.
I provide a CAD file of this remix below, but it contains the remnants of the original mesh. That's why the file size is so big. The OP did not provide a CAD file, so I had to hack the STL.
Printing recommendations
I used some cheap PLA+ from Amazon. I have not been gentle with this and it is holding up well. I think regular PLA will work fine with the settings below.
Model is oriented with the correct face on the build plate. Rotate as needed.
- 0.4 nozzle
- 0.20 or 0.28 layer height (I used 0.28)
- 4 walls
- 5 layers top/bottom
- 40% infill, cubic, adaptive cubic or gyroid
- No supports needed
(CAD file included)