Festool ETS EC150 Sander Clamp Mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Sander holder that slides onto clamp bar, allowing for use around the shop.
- Rating
- 0 / 5
- Likes
- 16
- Downloads
- 41
- Makes
- 0
- Views
- 685
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
For the Festool ETS EC150 Sander with or without a pad saver installed. If a thick, soft backing pad (FUSION-TEC ST-STF D150/MJ2-M8-SW/Item #202459) is installed, the sander will NOT fit.
This holder slides onto the bar of an Irwin Quick Grip Mini Clamp (1/2 inch - 12.7mm bar width). Clamp to a suitable horizontal work surface to keep the sander handy, and out of the way when not needed.
I provide a CAD file of this remix below, but it contains the remnants of the original mesh. That's why the file size is so big. The OP did not provide a CAD file, so I had to hack the STL.
Printing recommendations
I used some cheap PLA+ from Amazon. I have not been gentle with this and it is holding up well. I think regular PLA will work fine with the settings below.
Model is oriented with the correct face on the build plate. Rotate as needed.
- 0.4 nozzle
- 0.20 or 0.28 layer height (I used 0.28)
- 4 walls
- 5 layers top/bottom
- 40% infill, cubic, adaptive cubic or gyroid
- No supports needed
(CAD file included)