1 / 11
Orbiter 2.0 Prusa Bear Extruder Mount for Mosquito Hotends — zdjęcie 1
1 / 11

Orbiter 2.0 Prusa Bear Extruder Mount for Mosquito Hotends

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a Prusa Bear compatible mount for Mosquito hotends when using the official Orbiter v2.0 extruder.

Ocena
0 / 5
Polubienia
13
Pobrania
55
Wydruki
0
Wyświetlenia
1843
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

This is a Prusa Bear compatible mount for Mosquito hotends when using the official Orbiter v2.0 extruder. I have also added a 17.5mm PTFE cutting jig with a 45 degree bevel to fit the metal exit of the Orbiter better.

This mount uses the same location for the pinda probe and nozzle as the original Prusa MK3 extruder so it should work perfectly fine with the standard calibration and firmware settings. Make sure to adjust your e-steps and stepper voltage according to the Orbiter instructions.

Sensor addon can be found here: https://www.prusaprinters.org/prints/109069-orbiter-20-prusa-ir-filament-sensor-addon 

This was specifically designed using the Bear X-Carriage and has not been tested with any other version.

Category: 3D Printer Extruders

Tagi