Mighty Crafty water pipe attachment
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Why print an adapter when you can just print a functional water-filter structure for the mouthpiece?
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 51
- Wydruki
- 0
- Wyświetlenia
- 480
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Medical Tools
- Licencja
- Creative Commons — Public Domain
It's a very simple model. Designed to be filled partially with water. It slides right onto the mouthpiece of the crafty (And I assume by extent also the mighty) and allows one to suck the vapor through water.
while I'm not sure how similar it is to a bong attachment, it is a functional piece that softens the harshness of the vapor.
I printed it in TPU for it's ability to deform and grip onto the mouthpiece. I was able to get a watertight structure with default settings for layer height 0.24 in PRUSA.
The piece doesn't get too hot since it doesn't touch the main compartment, but if one sucks too hard you do run the risk of swallowing the water.
The piece is filled through the wider mouthpiece hole and slid onto the mouthpiece of the vape. The vapor intake tube is supported on the inside, allowing you to print with buildplate only support settings.
Print settings:
Filament: TPU recommended for guaranteed fit. PLA possible if you are confident in your printer.
Layer height: up to 0.26 tested But any should work.
Supports: Buildplate only. Do not do all supports.
Print orientation: Make sure to position it so it's on the flattened ‘bottom’ of the pipe, do NOT use the default orientation, it will almost certainly fail.