Prusa Core One Bank (Spardose)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Piggy Bank for a Core One
- Ocena
- 4,875 / 5
- Polubienia
- 103
- Pobrania
- 202
- Wydruki
- 8
- Wyświetlenia
- 2638
- Oceny
- 8
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The Core One is not the most expensive printer in the lineup, but since it will take a while for it to be delivered anyway, you might as well save up for it. What could be better than the right money box for it? So that you can always see directly what you're saving for.
The door can be printed in multicolor or individually.
Current version has a slightly larger display. With my version, it was still far too small in relation.
I printed the door in transparent, white and orange PLA.
The housing is made of galaxy black PLA from Prusa
The door itself is printed in the same size as the recess and should be pressed in relatively tightly. Please only do this once the handle has been glued on, otherwise it will be very difficult to get it out again. There are also cut-outs at the bottom for glides or rubber feet.