KWA QRF Mod 1 Mags (WIP)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mid Cap Mags for the KWA QRF Mod 1. 3 sizes included.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 28
- Wydruki
- 0
- Wyświetlenia
- 240
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Sports
- Licencja
- Creative Commons — Attribution — Share Alike
Update 2025-10-14: The 3MF for the short mag had the wrong BB catch and spring holder. I've changed them to the correct version.
Mags for the KWA QRF Mod 1 are hard to come by, so I made a mostly printable one. You'll need a couple nuts and bolts, a mag spring, and a pen spring. These printable parts are not compatible with the plastic parts from a QRF Mod1, though the springs will work. The spring holder needs supports, and the mag shell may need supports. I have put in support enforcers in the 3MFs.
Required hardware - short, mid, std:
M3 hex nuts - 4X, 5X, 5X
M3 flat head, 14mm - 3X, 4X, 4X
M3 flat head, 5mm - 1X
Mag Spring - Super Feed Springs work but are not recommended.
Spring - 4-5mm outer diameter would work. I used a 4.75mm/9/32" springs for the BB holder.
Use mid-cap mag springs. I find 0.5mm x 5mm x 10mm to work fine as well.
Print with 3 perimeters for durability.
Included 2 piece follower is EXCRUCIATINGLY frustrating to print, good luck.
For the follower, use supports everywhere with a 29deg threshold, and be careful removing them. You'll also have to break free the joint and work it until it pivots smoothly.