KWA QRF Mod 1 Mags (WIP)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Mid Cap Mags for the KWA QRF Mod 1. 3 sizes included.
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 28
- Makes
- 0
- Views
- 240
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Sports
- License
- Creative Commons — Attribution — Share Alike
Update 2025-10-14: The 3MF for the short mag had the wrong BB catch and spring holder. I've changed them to the correct version.
Mags for the KWA QRF Mod 1 are hard to come by, so I made a mostly printable one. You'll need a couple nuts and bolts, a mag spring, and a pen spring. These printable parts are not compatible with the plastic parts from a QRF Mod1, though the springs will work. The spring holder needs supports, and the mag shell may need supports. I have put in support enforcers in the 3MFs.
Required hardware - short, mid, std:
M3 hex nuts - 4X, 5X, 5X
M3 flat head, 14mm - 3X, 4X, 4X
M3 flat head, 5mm - 1X
Mag Spring - Super Feed Springs work but are not recommended.
Spring - 4-5mm outer diameter would work. I used a 4.75mm/9/32" springs for the BB holder.
Use mid-cap mag springs. I find 0.5mm x 5mm x 10mm to work fine as well.
Print with 3 perimeters for durability.
Included 2 piece follower is EXCRUCIATINGLY frustrating to print, good luck.
For the follower, use supports everywhere with a 29deg threshold, and be careful removing them. You'll also have to break free the joint and work it until it pivots smoothly.