40mm to 80 mm rain gutter junction hardware
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
3D printed adaptator to fit 40mm diameter pvc pipe to 80mm rain water gutter with a 2° slope.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 20
- Wydruki
- 0
- Wyświetlenia
- 183
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Share Alike
07
This is an adaptator to fit 40mm diameter pvc pipe to 80mm rain water pipe with a 2° slope for water drainage purposes.
I used it to connect an outdoor sink drain to the roof rain gutter pipe of our house.
Printing:
Any setup works, unfortunatly, supports are needed. For material, I prefer PETG over PLA for outdoor use due to its higher temperature resistance.
How to:
- Drill the gutter (dia 42-45mm), if needed, pre-drill with a shirter dialeter bit.
- Insert the tool (keep in mind the slope, refer to the printed ‘up’ wording)
- Mark the fastener hole location, remove the tool and drill them (dia 1.5mm)
- Apply silicon sealant on the inside of the tool
- Re-install the tool and screw it in place.
- Fit the 40mm pipe, apply silicon sealant as needed.
Notes:
- I used it for 6 month without any issue.
- I added the FreeCAD source file for tinkering.
Happy printing :)