40mm to 80 mm rain gutter junction hardware
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
3D printed adaptator to fit 40mm diameter pvc pipe to 80mm rain water gutter with a 2° slope.
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 20
- Makes
- 0
- Views
- 183
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution — Share Alike
07
This is an adaptator to fit 40mm diameter pvc pipe to 80mm rain water pipe with a 2° slope for water drainage purposes.
I used it to connect an outdoor sink drain to the roof rain gutter pipe of our house.
Printing:
Any setup works, unfortunatly, supports are needed. For material, I prefer PETG over PLA for outdoor use due to its higher temperature resistance.
How to:
- Drill the gutter (dia 42-45mm), if needed, pre-drill with a shirter dialeter bit.
- Insert the tool (keep in mind the slope, refer to the printed ‘up’ wording)
- Mark the fastener hole location, remove the tool and drill them (dia 1.5mm)
- Apply silicon sealant on the inside of the tool
- Re-install the tool and screw it in place.
- Fit the 40mm pipe, apply silicon sealant as needed.
Notes:
- I used it for 6 month without any issue.
- I added the FreeCAD source file for tinkering.
Happy printing :)