Ulanzi adjusting gasket grip
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
3d modeled a bigger diameter with texture to have better grip on the adjusting gasket.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 144
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution — Share Alike
The adjusting gasket was too small and hard to grab, I made this to friction fit I made the tolerances pretty small .2 or so, if you still find it too tight to press yours in may want to calibrate your printer.
I printed this in ABS, PLA should be fine, and this should be fine to print in ASA, or PETG for UV resistance. I printed at .2mm layer height, walls 5 is what I used less is probably fine and for infill I had 50% gyroid or adaptive cubic, but 100% infill will be fine too or 6 walls its not a model thats going to be abused anyways.