Universal-ish Milk Frother Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Milk Frother holder that can fit frothers with diameter 25-34mm comfortably. With shaft diameter max 3mm.
- Ocena
- 5 / 5
- Polubienia
- 16
- Pobrania
- 95
- Wydruki
- 1
- Wyświetlenia
- 243
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Needed to make a holder for 2 frothers, where each was a different size and shape.
So I decided to make one that would fit them both.
Fits max 34mm in diameter frother and max 3mm shaft diameter.
I printed it with ASA, but any filament should work just fine.
No supports needed if you have good overhang performance.
For attaching I used VHB tape,
but there is also a version with 3 4mm screws.
For best results I recommend painting the seams on the bottom:
Also this is not necessary but will help with strength, if you increase infill for the upper part. (I used ~70%):