Universal-ish Milk Frother Holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Milk Frother holder that can fit frothers with diameter 25-34mm comfortably. With shaft diameter max 3mm.
- Rating
- 5 / 5
- Likes
- 16
- Downloads
- 95
- Makes
- 1
- Views
- 243
- Reviews
- 3
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Needed to make a holder for 2 frothers, where each was a different size and shape.
So I decided to make one that would fit them both.
Fits max 34mm in diameter frother and max 3mm shaft diameter.
I printed it with ASA, but any filament should work just fine.
No supports needed if you have good overhang performance.
For attaching I used VHB tape,
but there is also a version with 3 4mm screws.
For best results I recommend painting the seams on the bottom:
Also this is not necessary but will help with strength, if you increase infill for the upper part. (I used ~70%):