1 / 2
MK3/MK4 black PSU holder for Ikea Lack enclousure (rear mount) — zdjęcie 1
1 / 2

MK3/MK4 black PSU holder for Ikea Lack enclousure (rear mount)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A frame for holding the black PSU from the MK3 and MK4 to the rear of the Ikea Lack enclosure.

Ocena
5 / 5
Polubienia
25
Pobrania
106
Wydruki
5
Wyświetlenia
589
Oceny
4

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
GNU General Public License v3.0

There have been a couple of Ikea Lack enclosures popularised by Prusa, the V1 and V2. Both these enclosures provide the option to mount the PSU on the outside of the enclosure, but underneath the base which means it's not possible to stack multiple Lack enclosures, and it's difficult to access when needing to do maintenance.

This print allows the PSU to be mounted externally on the rear of the enclosure, freeing up the lower space and keeping the PSU in the same orientation as if mounted on the printer.

Additional parts needed:

  • 3× pan head self-tapping screw, 5mm dia. 20 mm length (same as used in the Lack enclosure V2)
  • 2x pan head M4 screw, MAXIMUM thread length 18mm

Print both the cradle and the rectangular template in PETG, using supports to fill the cutout in the cradle.

Assembly

Check the two “legs” at the back of the enclosure. Identify the leg closest to where the printer's power cables exit the electronics box. Place the rectangular template on the rear of that leg, so it's as close to the bottom as possible; if using the Lack enclosure V2 parts, it can rest on the edge of the plastic part the leg is screwed into (see photo for reference). The two ridged edges should face the leg, and assist with maintaining alignment. Ensure it is oriented correctly (two upper holes, one lower hole).

Mark the holes and drill carefully (the leg is mostly hollow). Fix the cradle through the rectangular plate onto the leg, using the 5x20mm self-tapping screws. They should end up flush with the cradle so there is no obstruction to the PSU.

Push the PSU into place. It can be made slightly easier by flicking the power switch to the OFF position, and letting it flick to the ON position as it enters the cutout. The mains power block should fit comfortably into the cutout, and the notches at the bottom of the PSU should locate into the two pegs.

Secure the PSU in place using the two M4 screws. IMPORTANT NOTE: Do not use M4 screws with a thread longer than 18mm! If the threads are long enough to go 2-3mm into the metal PSU casing, it will be secure, but a thread longer than 18mm may stert to interfere with the PSU's internal components!

Wire the printer into PSU through the enclosure, following the usual assembly instructions for the printer (paying attention to polarity). There is just enough length to do so through the dedicated power cord port in the V2 enclosure, but you may want to put a 1cm hole through the rear acrylic near the bottom and route the power cables through that to allow some slack.

Tagi