Wowstick 1F+ Handle Grip
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I found the anodised finish on the handle of my Wowstick 1F+ to be a bit slippery when manually tightening/loosening…
- Ocena
- 0 / 5
- Polubienia
- 19
- Pobrania
- 66
- Wydruki
- 0
- Wyświetlenia
- 409
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
I found the anodised finish on the handle of my Wowstick 1F+ to be a bit slippery when manually tightening/loosening screws. So I made a handle grip to go over the Wowstick to make it feel more like a traditional screwdriver. It has a hole in the end to allow the USB cable to plug in for charging.
The handle is designed to be printed in PLA, and has a very tight fit on the Wowstick, so no glue or anything is required to stop it slipping. To fit the grip, I heated it up with a hot air gun until it was about 70 deg Celsius then the PLA was soft enough to easily slide on.
Print Settings
Printer Brand:
Prusa
Printer:
i3 MK2S
No
Supports:
Yes
0.20mm
Infill:
50%
Filament:
Generic PLA
Category: Tools