Toroid Holder - T37
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a clamp that holds small electronics toroids. This one is designed for T37 but will also work with T50.
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 144
- Wydruki
- 0
- Wyświetlenia
- 397
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a clamp that holds small electronics toroids. This one is designed for T37 but will also work with T50. This holds the toroid securely. It will save your finger tips and makes holding it much easier.
The slide locks the toroid in place even if you set it down. The slide should be put on from the back. It should also be slid down past the split to add or remove toroid.
No supports needed. I printed mine with PLA. You want something fairly rigid as you don't want a lot of flex.
You may need to run a small jewelers file through the slide to get it to go over easily. You don't want it to be too loose so it stays in place.