Toroid Holder - T37
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a clamp that holds small electronics toroids. This one is designed for T37 but will also work with T50.
- Rating
- 0 / 5
- Likes
- 11
- Downloads
- 144
- Makes
- 0
- Views
- 397
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial
This is a clamp that holds small electronics toroids. This one is designed for T37 but will also work with T50. This holds the toroid securely. It will save your finger tips and makes holding it much easier.
The slide locks the toroid in place even if you set it down. The slide should be put on from the back. It should also be slid down past the split to add or remove toroid.
No supports needed. I printed mine with PLA. You want something fairly rigid as you don't want a lot of flex.
You may need to run a small jewelers file through the slide to get it to go over easily. You don't want it to be too loose so it stays in place.